Impex GD-800 Manual do Proprietário

NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Pack Assembly Instruction Pa

Step 2-2 (See Diagram 2-2) A.) Attach the Right & Left Connecting Tube (#10 & #11) onto the Upper Cantilever (#9) from each side. B.) Insert

Step 2-3 (See Diagram 2-3) A.) Insert the other Lounge Chair Side Frame (#32) through the left sleeve on the Nylon Sheet (#35) all the way into the

Step 2-4 (See Diagram 2-4) A.) Secure the Lounge Chair Side Frames (#32) to the Connecting Tubes (#10 and 11) with two M8 x ¾” Allen Bolts (#15), Ø

Step 2-5 (See Diagram 2-5) A.) Attach the Lounge Chair Support (#30) to the two Lounge Chair Side Frames (#32). B.) Secure it with four M8 x ¾” Alle

Step 2-6 (See Diagram 2-6) A.) Attach the Lounge Chair Support (#30) onto the bracket on the Lower Cantilever (#28). B.) Secure it with four M8 x ¾”

Step 3-1 (See Diagram 3-1) A.) Insert four Support Tubes (#3) that are in diagonal direction to each other into the holes on the Canopy Support Fra

Step 3-2 (See Diagram 3-2) A.) Insert the end of the Tubes (#3) into the pockets on the Canopy (#1). DIAGRAM 3-2 15

Step 3-3 (See Diagram 3-3) A.) Push out the two Support Tubes (#3) that were not tightened in step 3-2 above, away from the center. B.) Secure each

Step 4-1 (See Diagram 4-1) A.) Hang the Cantilever Hook (#40) onto the Upper Frame Hook (#41). B.) Attach two Cables (#19) to the hook underneath the

Step 4-2 (See Diagram 4-2) A.) Use the Nylon Sheet String (#34) to secure the Nylon Sheet to the Lounge Chair End Frame (#33). Use the String (#37) t

TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOTICE

OPERATION 1. The chair can be used with or without the bottom cables attached. It is recommended to use the cables attached until you are familiar

EXPLODED DIAGRAM 20

Parts list KEY NO. DESCRIPTION Q’ty 1 Canopy 1 2 Support Tube End Cap 6 3 Support Tube 6 4 Cone-shaped Canopy Support End Cap 6

IMPEX® INC. LIMITED WARRANTY IMPEX INC ("IMPEX®") warrants this product to be free from defects in workmanship and material, under normal

IMPORTANT SAFETY NOTICE Please read the entire manual before assembling or operating the equipment. In particular, note the following safety pre

WARNING LABEL PLACEMENT 3

HARDWARE IDENTIFIER Part# Description Identifier #12 Ø ¾” Washer (Qty 6)

ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrench NOTE: It is strongly recommended two or more p

Note: When installed the Ø 1” Washer, make sure the lip of the washer faces outside, away from the frame. The groove inside the Plastic Cover shou

Step 1-2 (See Diagram 1-2) A.) Insert the Upper Frame (#8) into the opening on the Main Post (#24). B.) Securely tighten them together with six M10

Step 2-1 (See Diagram 2-1) A.) Insert the Lower Cantilever (#28) into the Upper Cantilever (#9). B.) Securely tighten them together with six M10 x ¾”