Impex WM-1505 Manual do Utilizador

NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instructi

STEP 2 (See Diagram 2) A.) Slide two Ø2 ½” x 1” Rubber Bumpers (#65) onto the Guide Rods. B.) Slide 9 Weight Plates (#33) onto the Guide Rods. M

DIAGRAM 2 10

STEP 3 (See Diagram 3) A.) Attach the Front Press Base (#11) to the Upper Frame (#4). Secure it with one Long Axle (#46), two Ø ¾” Washers (#83),

STEP 4 (See Diagram 4) A.) Attach the Leg Developer (#7) to the bracket on the Leg Developer Holder (#1). Secure it with a Leg Developer Axle (#47),

CABLE LOOP DIAGRAM 13

STEP 5 (See Diagram 5 & Cable Loop Diagram) A.) Attach the 142” Upper Cable (#35) to the opening at the front of the Upper Frame (#4). Note

DIAGRAM 5 15

STEP 6 (See Diagram 6 & Cable Loop Diagram) A.) Attach one end of the 119” Butterfly Cable (#37) to the hook on the Right Butterfly (#6). B.) D

STEP 7 (See Diagram 7 & Cable Loop Diagram) A.) Attach the 128” Lower Cable (#36) to the open bracket on the bottom of the Leg Developer (#7)

DIAGRAM 7 18

TABLE OF CONTENTS BEFORE YOU BEGIN...……….. 1 IMPORTANT SAFETY NOT

PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Leg Developer Holder 1 2 Rear Base Frame 1 3 Lower Vertical Frame 1 4 Upper Frame 1 5 Left Butterfly

20

IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a p

WARNING LABEL REPLACEMENT The warning labels shown here have been placed on the Rear Base and Upper Frame. If the labels are missing or illegible,

HARDWARE PACK 4

HARDWARE PACK 5

HARDWARE PACK 6

ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches, two Allen Wrenches, and one Philips Screwdriver. NOTE: It is

DIAGRAM 1 8